Manual drive R17 with hand crank (Gear ratio 1:16)

Product information "Manual drive R17 with hand crank (Gear ratio 1:16)"
 Our hand drive comes along with a gear ratio of 1:16.

1-inch shafts can be moved with the supplied hand crank and the separately available adapter.

The load limit of our manual drive is 70 Nm.

0 of 0 reviews

Leave a review!

Share your experiences with other customers.


Customers who bought this item also bought:

adapter-98-8-zoll
Adapter 1" for manual drive - screwable
This adapter connects our manual drive system with an 1 inch tube. You can connect the pre-drilled shaft and the hand drive with a m8 screw.

€16.49*
kreuzgelenk-1-zoll
U-joint incl. Adapter up to 1" shaft
 The cross joint make it possible to the bend the drive shaft up to 34 degrees.The special feature of this connection is that the drive shafts are via a screwdriving and not - as usual - by heat sealings connected.This construction is very stable, the screwing withstands higher torsional forces as well as corrosion is avoided.In addition you benefit from a fast assembly.The cross joint can be connected and used with our manual hand drives without an adapter.

€59.90*
seiltrommel_typ1
Cable drum for 1" drive shaft
This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems.The two-halves construction allows the subsequent mounting of the cable drum on the drive shaft. They’re connected easily and fast with 2 hexagon bolts (M6x50) and 2 srew nuts (not included). The screws are used as well to fix the drive shaft. The cable drum is made of impact-resistant plastic which saves the wire rope and the drive shaft as well as it increases the service life.Can be used with cords with a diameter up to 3 mm and is suitable for 1 inch (34 mm) drive shafts.Capacity of cable drum: up to 5,70 m

€18.90*